TM-9-2320-366-20-3

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 3 OF 5

FEBRUARY 2006

CHANGE 3

TM-9-2320-366-20-3 - Page 457 of 1396

AIR PRESSURE TEST STE/ICE-R TEST #50

Tag air hose and connection piont prior to

disconnecting

NOTE

WARNING

Wear protective goggles to protect against

possible injury from release of high pressure

air.

Failure to comply may result in injury to

personnel.

(13) Disconnect M1089 30K winch pneumatic

test adapter from pneumatic solenoid L19

port 1.

(14) Connect air hose to pneumatic solenoid

L19 port 1.

(15) Close LH and RH catwalks.

TM 9-2320-366-20-3

Change 1

2-2423

(1) Open LH and RH catwalks.

(2) Disconnect air hose from pneumatic

manifold solenoid L19 port 1.

(3) Remove tube nipple from M1089 30K

winch pneumatic test adapter.

(4) Connect M1089 30K winch pneumatic test

adapter on pneumatic manifold solenoid

L19 port 1.

(5) Install STE/ICE-R 0-1000 PSI transducer on

M1089 30K winch pneumatic test adapter.

(6) Start engine (TM 9-2320-366-10-1) and

allow vehicle to build air pressure.

(7) Position MAIN WINCH LH FREESPOOL

switch to ON.

(8) Perform STE/ICE-R Test #50 and note

reading on STE/ICE-R.

(9) If 75-120 PSI (518-827 kPa) is not present,

repair 30K winch pneumatic solenoid or

replace solenoid L19 (para 17-29).

(10) Shutdown engine (TM 9-2320-366-10-1).

(11) Drain air tanks (TM 9-2320-366-10-1).

(12) Position MAIN WINCH LH FREESPOOL

switch to OFF.