TM-9-2320-366-20-4

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 4 OF 5

FEBRUARY 2006

CHANGE 3

TM-9-2320-366-20-4 - Page 1023 of 1558

TM 9-2320-366-20-4

Change 2

14-93

14-12.

PINTLE HOOK REPLACEMENT

This task covers:

a. Removal

b.

Installation

c.

Follow-On Maintenance

INITIAL SETUP

Equipment Conditions

Engine shut down (TM 9-2320-366-10-1)

Tools and Special Tools

Tool Kit, Genl Mech (Item 46, Appendix C)

Goggles, Industrial (Item 15, Appendix C)

Wrench, Torque, 0-600 lb-ft (Item 60, Appendix C)

Wrench Set, Socket (Item 50, Appendix C)

Materials/Parts

Nut, Self-locking (4) (Item 161, Appendix G)

Pin, Cotter (Item 236.1, Appendix G)

Grease, Automotive and Artillery (GAA) (Item

22, Appendix D)

Personnel Required

(2)

a. Removal.

NOTE

(1)

Remove cotter pin (1) from nut (2).

Discard cotter

pin.

(2)

Remove nut (2) and washer (3) from pintle hook

(4).

(3)

Remove pintle hook (4) from rear crossmember (5).

(4)

Remove four self-locking nuts (6), screws (7), and

support (8) from rear crossmember (5).

Discard

self-locking nuts.

WARNING

WARNING

Wear appropriate eye protection when

working under vehicle due to the

possibility of falling debris.

Failure to

comply may result in injury to personnel.

All pintle hooks are removed the same way.

M1083/M1093 shown.

Pintle hook weighs approximately 65 lbs

(30 kgs). Attach a suitable lifting device

prior to removal. Failure to comply may

result in injury to personnel or damage to

equipment.