TM 9-2320-366-20-4
(20) Install tool box lid (35) in two hinges (27) with four
lockwashers (39) and self-locking nuts (40).
NOTE
Step (21) requires the aid of an assistant.
(21) Position stay (41) on tool box (9) with four screws (42),
washers (43), and self-locking nuts (44).
(22) Tighten four screws (42) to 8-10 lb-ft (11-13 N·m).
(23) Close tool box lid (35).
d. Installation.
WARNING
Rear tool box weighs approximately 75 lbs
(34 kgs) empty. Attach a suitable lifting
device prior to installation.
Failure to
comply may result in injury to personnel
or damage to equipment.
NOTE
• Both tool boxes are installed the same way.
Rear tool box shown.
• Steps (1) and (2) require the aid of an assistant.
(1) Position tool box (1) on support structure (2).
Change 1
16-177