TM-9-2320-366-20-4
M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)
TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 4 OF 5
FEBRUARY 2006
CHANGE 3
TM-9-2320-366-20-4 - Page 461 of 1558
TM 9-2320-366-20-4
Change 2
8-37
NOTE
(3)
Position gasket (4) and transmission oil filter cover (2)
on transmission control module (5) with six screws (6).
NOTE
(4)
Position transmission oil filter cover (2) on trans-mission
control module (5) with six screws (6).
(5)
Tighten six screws (6) to 38-45 lb-ft (52-61 N
•
m) in
sequence shown.
(6)
Position universal joint (7) in drive yoke (8) with two
bearing cups (9) and four screws (10).
(7) Tighten four screws (10) to 26-35 lb-ft (35-47 N
•
m).
(7.1) Fold down tabs on bearing cups (9).
(7.2) Tighten four screws (10) to 26-35 lb-ft (35-47 N
•
m).
CAUTION
Perform step (3) on transmissions SN
6510069120 and higher.
Perform step (4) on transmissions SN lower
than 6510069120
Ensure needle bearings are aligned prior to
installation of bearing cups on universal joint
trunnions.
Failure to comply may result in
damage to equipment.
NOTE
When correct torque is reached, bearing cap
screw small hex head will break off.
NOTE
Perform step (7.1) on bearing cups equipped
with tabs.
Back to Top
