TM-9-2320-366-20-4
M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)
TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 4 OF 5
FEBRUARY 2006
CHANGE 3
TM-9-2320-366-20-4 - Page 48 of 1558
TM 9-2320-366-20-4
7-372
Change 2
7-80.
ENGINE CONTROL CABLE ASSEMBLY REPLACEMENT (CONT)
(10) Apply electrical tape to terminal lug TL110 (21).
(10) Install dust boot (20) on engine control cable
assembly (1).
(11) Position terminal lug TL110 (21) on voltage regulator
(22) with washer (23) and self-locking nut (24).
(12) Tighten self-locking nut (24) to 25 lb-in. (3 N
•
m).
(13) Position dust boot (20) on terminal lug TL110 (21).
(14) Install dust boot (25) on engine control cable
assembly (1).
(15) Position terminal lug TL35 (26) on voltage regulator
(22) with washer (27) and self-locking nut (28).
(16) Tighten self-locking nut (28) to 25 lb-in. (3 N
•
m).
(17) Position dust boot (25) on terminal lug TL35 (26).
(18) Install terminal lug TL6 (29) in dust boot (30).
(19) Position terminal lugs TL2 (31) and TL6 (29) on
alternator (32) with insulation washer (33), washer
(34), and self-locking nut (35).
(20)
Tighten self-locking nut (35) to 40 lb-in. (5 N
•
m).
(21)
Position dust boot (30) on terminal lugs TL6 (29)
and TL2 (31).
(22)
Position terminal lugs TL8 (36) and TL5 (37) on
alternator (32) with washer (38), lockwasher (39),
and screw (40).
(23)
Tighten screw (40) to 40 lb-in. (5 N
•
m).
CAUTION
Insulation washer must be installed with flat
side up.
Failure to comply may result in
damage to equipment.
NOTE
•
Perform step (10) if replacing alternator P/N
N1506-1 (12420852) with alternator P/N 1509-1
(12422863).
•
Install plastic cable ties to TL110 and tie wrap
wire away from alternator.
NOTE
Perform steps (10.1) through (13) on alternator P/N
N1506-1 (12420852).
Back to Top
