TM-9-2320-366-20-5
M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)
TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 5 OF 5
FEBRUARY 2006
CHANGE 3
TM-9-2320-366-20-5 - Page 67 of 1158
TM 9-2320-366-20-5
17-9. M1084/M1086 MATERIAL HANDLING CRANE (MHC) TUBING REPLACEMENT
This task covers:
a. Hydraulic Tubing Locations
b. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
MHC positioned over cargo bed (TM 9-2320-366-10-1).
Engine shut down (TM 9-2320-366-10-1).
Tools and Special Tools
Tool Kit, Genl Mech (Item 46, Appendix C)
Goggles, Industrial (Item 15, Appendix C)
Pan, Drain (Item 24, Appendix C)
Materials/Parts
Dispenser, Pressure Sensitive Adhesive
Tape (Item 20, Appendix D)
Cap and Plug Set (Item 14, Appendix D)
Ties, Cable, Plastic (Item 69, Appendix D)
a. Hydraulic Tubing Locations.
WARNING
•
Wear appropriate eye protection when working under vehicle due to the possibility of falling
debris. Failure to comply may result in injury to personnel.
•
Prolonged contact with lubricating oil (MIL-L-2104) may cause a skin rash. Skin and clothing that
come in contact with lubricating oil should be thoroughly washed immediately. Saturated clothing
should be removed immediately. Areas in which lubricating oil is used should be well ventilated
to keep fumes to a minimum. Failure to comply may result in injury to personnel.
CAUTION
Cap or plug tubes and connection points to prevent contamination of M1084/M1086 MHC hydraulic
system. Failure to comply may result in damage to equipment.
NOTE
• Refer to
Table 17-2. M1084/M1086 Material Handling Crane (MHC) Hydraulic Tubing Locations
for
tubing locations on the M1084/M1086 MHC. It may not be necessary to remove all hydraulic tubes at one
time.
• Tag tubes and connection points prior to removal.
• Remove plastic cable ties as required.
• Remove clamps and support brackets as required.
• Position drain pan to collect oil.
17-31
Back to Top
