TM 9-2320-366-34-2
10-60.2
Change 2
10-9.
REAR AXLE DIFFERENTIAL CARRIER REPLACEMENT (CONT)
(6) Position five washers (4) and bolts (5) in rear axle
differential carrier (1).
(7)
Tighten 12 bolts (5) to 74-96 lb-ft (100-130 N•m).
(8)
Remove drive shaft (6) from frame (7).
WARNING
CAUTION
Check bearing cups to ensure all needle
bearing are in place prior to installation.
Replace bearing cups if needle bearings are
missing or out of place.
Failure to comply
may result in damage to equipment.
Do not use steel hammers to seat bearing
cups in drive yokes.
Failure to comply
may result in injury to personnel or
damage to equipment.
NOTE
•
Wipe end of yoke bearing bore prior to
installation.
•
Step (8) requires the aid of an assistant.