TM-9-2320-366-34-3

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE; VOLUME NO. 3 OF 4

AUGUST 2005

CHANGE 2

TM-9-2320-366-34-3 - Page 667 of 1178

TM 9-2320-366-34-3

Change 2

16-441

c. Adjustment.

(1)

Install tee fitting (1) on 90-degree fitting (2).

(2)

Install snubber (3) on tee fitting (1).

(3)

Install transducer (4) on snubber (3).

(4)

Install cable (5) to transducer (4).

(5)

Position hose (6) on tee fitting (1).

(6)

Deleted.

(7)

Tighten hose (6) to 35-39 lb-ft (47-53 N•m).

(8)

Open hydraulic reservoir supply and return valves

(TM 9-2320-366-10-2).

(9)

Raise underlift approximately two feet (TM 9-2320-

366-10-2).

(10)

Verify STE/ICE-R reads 1950 psi (13445 Kpa).

(11) Loosen jam nut (8) on counterbalance valve (9).

(12)

Operate underlift (TM 9-2320-366-10-2).

(13)

Adjust screw (10) until STE/ICE-R reads 1950 psi

(1345 Kpa).

(14)

Hold adjustment screw (10) and tighten jam nut (8)

on counterbalance valve (9).

CAUTION

NOTE

Perform steps (11) through (14) if pressure

reading was not 1950 psi (13445 Kpa).

Steps (12) and (13) must be preformed at

the same time to get a correct reading.

Failure to comply may result in damage to

NOTE

Turn adjustment screw clockwise to increase

pressure and counterclock-wise to decrease

pressure.