TM 9-2320-366-34-4
18-90
Change 2
18-7.
DIGITIZATION KIT INITIAL INSTALLATION (CONT)
(74) Apply sealant to three of four screws (83).
(75) Install EPLRS shelf (84) and inside support (85) on
support legs (73) with four washers (86) and screws
(83).
Refer to
Table 18-1
for hole locations.
(76) Position outer side support (87) on inner side
support (85) with three washers (88), screws (89),
and self-locking nuts (90).
(77) Position rear and mid support (91) on EPLRS shelf
(84) with three washers (92), screws (93), and self-
locking nuts (94).
(78) Position six washers (95), screws (96), and self-
locking nuts (97) in support legs (73).
(79) Tighten three self-locking nuts (94 and 97) to 110-
120 lb-in (12-14 N•m).
WARNING
Adhesives,
solvents,
and
sealing
compounds can burn easily, can give off
harmful vapors, and are harmful to skin
and clothing.
Keep away from open fire
and use in a well-ventilated area.
If
adhesive, solvent, or sealing compound
gets
on
skin
or
clothing,
wash
immediately with soap and water.
Failure
to comply may result in injury to
personnel.