TM 9-2320-366-34-4
18-88
Change 2
18-7.
DIGITIZATION KIT INITIAL INSTALLATION (CONT)
c.
Radio Rack Assembly.
(65) Place four support legs (73) in alignment,
(66) Count and mark holes in support legs (73) used to
mount shelves.
Refer to
Table 18-1
for locations.
(67) Remove paint from support legs (73) at shelf hole
locations and top-bottom hole locations.
Table 18-1 Support Leg Hole Locations
Shelf
Hole Location
FBCB2 Shelf
6
EPLRS Shelf
17
Power Distribution Shelf
26
Lower Head Rest Support
33
Singars Shelf
36
CAUTION
If radio rack is assembled outside of cab, do
not install top and bottom support plates until
rack is in cab.
Failure to comply may result
in damage to equipment.
NOTE
All holes are the same.
No. 6 hole shown.