TM 9-2320-366-34-4
Change 2
18-79
(4) Enlarge holes at location (4) to 17/32” (13 mm).
(5) Enlarge two holes in plastic cab liner (5) at location
(4) to 1/2” (13 mm).
(6) Apply primer and paint to rear cab wall (2) holes at
locations (4).
(7) Apply primer and paint to two rivnuts (6).
(8) Install rivnuts (6) in rear cab wall (2) holes at
location (4).
(9) Position RH roof template (7) on cab roof (8) with two
clamps.
(10) Drill six 3/16” (5 mm) pilot holes at locations (9).
(11) Remove two clamps and RH roof template (7) from
cab roof (8).
CAUTION
Enlarge holes only in plastic wall covering.
Pull plastic away from rear cab wall if
necessary.
Failure to comply may result in
damage to equipment.
NOTE
Use primer and paint as indicated in TM
Paint TB43-0242.