TM-9-2320-387-10

TRUCK, UTILITY: S250 SHELTER CARRIER, 4X4, M1113

OPERATOR’S MANUAL

OCTOBER 2001
CHANGE 1
TM-9-2320-387-10

  TM-9-2320-387-10 - Page 128 of 277

TM 9-2320-387-10
2-80
a. Tool Removal.
(1)
Disconnect three strap assemblies (2) in right footwell area (1) securing
ax (4), max tool carrying bag (5), and jack and tools bag (3). Remove ax (4) and max
tool carrying bag (5).
(2)
Remove the following attachments from max tool carrying bag (5):
• Reversible rake/hoe attachment (12)
• Rake/hoe thumbscrew attachment (11)
• Shovel attachment (6)
• Six safety locking pins (8)
• Broad pick attachment (10)
• Pick attachment (9)
• Mattock attachment (7)
NOTE
• Using the ax and attachments, the max tool kit can be incorporated
into seven basic hand tools.
• Ax blade must be covered with sheath before using kit.
• Read all safety and assembly instructions enclosed with max tool
kit before using kit.
b. Reversible Rake/Hoe Attachment.
(1)
Connect rake/hoe attachment (12) (with either rake or hoe in the working
position) into socket (13) on end of ax (4).
NOTE
Thumbscrew must be seated tightly in rake/hoe attachment and socket
of ax. Check thumbscrew often to be sure it does not work loose.
(2)
Install thumbscrew (11) on rake/hoe attachment (12) and in socket (13) of
ax (4). Tighten thumbscrew (11).
(3)
To remove rake/hoe attachment (12), remove thumbscrew (11) from
rake/hoe attachment (12) and ax (4).
c. Shovel Attachment.
NOTE
Shovel attachment is shown. Broad pick, pick, and mattock
attachments are attached basically the same.
(1)
Connect shovel attachment (6) into socket (13) on end of ax (4).
(2)
Insert safety locking pin (8) into hole in end of taper on shovel attachment (6).
(3)
To remove shovel attachment (6), remove safety locking pin (8) from
shovel attachment (6) and ax (4).
d. Tool Installation.
(1)
Replace attachments in the max tool carrying bag (5).
(2)
Install max tool carrying bag (5) and jack and tools bag (3) with three strap
assemblies (2) in right footwell area (1) of vehicle.
2-24.
MAX TOOL KIT STOWAGE (M1113) OPERATION


Back to Top