TM-9-2320-387-24-1

TRUCK, UTILITY: S250 SHELTER CARRIER, 4X4, M1113

TECHNICAL MANUAL; UNIT, DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE, VOLUME 1

DECEMBER 1997

CHANGE 1

TM-9-2320-387-24-1 - Page 1090 of 1205

TM 9-2320-387-24-l

1 8-l 8. STEERING COLUMN REPLACEMENT (Cont’d)

b. Installation

1.

2.

3.

4.

Install steering column (6) on mounting bracket (4) with two washers (181, screws (191, washers (181,

and locknuts (20). Tighten locknuts (20) finger-tight.

Install intermediate shaft (16) on steering column (6) with washer (14), capscrew (1% washer (141,

and locknut (12). Tighten locknut (12) to 40-50 lb-ft (54-68 Nom).

Connect lead 25A (21) to steering column (6).

Install two brackets (9) on steering column (6) with washer (111, capscrew (131, washer (111, and

locknut (10).

5.

Install ground wire 57C (8) on steering column (6) with screw (7) and nut and lo&washer assembly (17).

NOTE

Ensure washer and pm locking tabs are in the UP position.

6.

7.

8.

Install steering column (6) on mounting bracket (41 with pin (51, washer (31, lockwasher (21, and

locknut (1). Tighten locknut (1) finger-tight.

Position steering column (6) in upright position and tighten locknut (1) to 12-15 lb-R (16-20 Nom).

Tighten two locknuts (20) to 9-11 lb-R (12-15 Nom).

8-52