TM-9-2320-387-24-1

TRUCK, UTILITY: S250 SHELTER CARRIER, 4X4, M1113

TECHNICAL MANUAL; UNIT, DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE, VOLUME 1

DECEMBER 1997

CHANGE 1

TM-9-2320-387-24-1 - Page 1120 of 1205

TM9-2320-387-24-l

9-6. REAR BUMPER BRACE REPLACEMENT

This task covers:

a. Removal

b. Installation

INITIAL

SETUP:

Tools

General mechanic’s tool kit:

automotive (Appendix B, Item 1)

Maintenance and repair shop equipment:

automotive (Appendix B, Item 2)

Materials/Parts

Manual References

TM 9-2320-387-24P

Maintenance Level

Unit

Three locknuts (Appendix G, Item 121)

NOTE

Replacement procedures for inner and outer bumper braces are

basically the same. This procedure covers the outer bumper brace.

VI

1.

Remove locknut (51, washer (2), capscrew (11, and washer (2) from rear bumper brace (3) and frame

rail (4). Discard locknut (5).

2.

Remove two locknuts (91, washers (71, capscrews (6), washers (71, and rear bumper brace (3) from rear

.

bumper (8). Discard locknuts (9).

b. Installation

1.

Install rear bumper brace (3) on rear bumper (8) with two washers (71, capscrews (61, washers (71, and

locknuts (9).

2.

Install rear bumper brace (3) on frame rail (4) with washer (2), capscrew Cl), washer (21, and locknut (5).

Tighten locknuts (5) and (9) to 90 lb-R (122 Nom).

9-6