TM-9-2320-387-24-1

TRUCK, UTILITY: S250 SHELTER CARRIER, 4X4, M1113

TECHNICAL MANUAL; UNIT, DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE, VOLUME 1

DECEMBER 1997

CHANGE 1

TM-9-2320-387-24-1 - Page 1125 of 1205

q

TM 9-2320-387-24-l

9-9. TOWING PINTLE MAINTENANCE

This task covers:

a.

Removal

b.

Disassembly

c.

Cleaning

d.

Assembly

e.

Installation

INITIAL SETUP:

Tools

General mechanic’s tool kit:

automotive (Appendix B, Item 1)

Maintenance and repair shop equipment:

automotive (Appendix B, Item 21

nIaterialslParts

Two cotter pins (Appendix G, Item 381

Drivescrew (Appendix G, Item 47)

‘Ikvo

locknuts (Appendix G, Item 122)

Four locknuts (Appendix G, Item 1461

Drycleaning solvent (Appendix C, Item 26)

Manual References

TM 9-2320-387-10

TM 9-2320-387-24P

General Safety Instructions

Drycleaning

solvent isflammable and will not be

used near an open flame.

Maintenance

Level

Unit

NOTE

Contact DS maintenance for fabrication instructions of optional towing pintle.

[I

NOTE

l

Perform steps 1 and 2 for rear-mounted towing pintle.

l

Perform steps 3 and 4 for optional towing pintle mounted to the front bumper.

1.

Remove cotter pin (31, slotted nut (21, washer (4), and towing pintle (9) from rear bumper (7).

Discard cotter pin (3).

2.

Remove four nuts (11, washers (111, capscrews (101, washers (111, two support plates (61, backing

plate (51, and safety chain plate (81 from rear bumper (7).

9-l 1