TM-9-2320-387-24-1

TRUCK, UTILITY: S250 SHELTER CARRIER, 4X4, M1113

TECHNICAL MANUAL; UNIT, DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE, VOLUME 1

DECEMBER 1997

CHANGE 1

TM-9-2320-387-24-1 - Page 784 of 1205

TM 9-2320-387-24-

1

4-33. GLOW PLUG CONTROLLER REPLACEMENT

This

task covers:

a. Removal

b. Installation

INITIAL

SETUP:

TOOIS

General mechanic’s tool kit:

automotive (Appendix B, Item 1)

Maintenance and repair shop equipment:

automotive (Appendix B, Item 2)

Materials/Parts

Grease (Appendix C, Item 36)

Sealing compound (Appendix C, Item 61)

Manual References

TM 9-2320-387-10

TM

9-2320-387-24P

Equipment Condition

l

Battery ground cables disconnected (para. 4-68).

l

Hood raised and secured (TM 9-2320-387-10).

Maintenance Level

unit

NOTE

It may be necessary to clamp surge tank-to-lower radiator tube to

prevent loss of coolant.

rzEEi-j

1.

Disconnect multiple connector (2) from glow plug controller (1).

2.

Remove glow plug controller (1) from water crossover (3).

b. Instaliation

CAUTION

l

Do not attempt to start engine unless controller has been

mounted in engine for a minimum of 10 minutes, or ifall glow

plugs are disconnected Damage to glow plugs may result.

l

Do not over-tighten controller. Damage to water crossover may

result.

1.

Apply sealing compound to

threads

of glow plug controlIer (1).

2.

Install glow plug controller (11 on water crossover (3). Tighten controIler (1) to 14-20 lb-R

(19-27 Nem).

3.

Apply grease to pins (4) of glow plug controller (1).

4.

Connect multiple connector (2) to glow plug controller (1).

4-58