TM-9-2320-387-24-1

TRUCK, UTILITY: S250 SHELTER CARRIER, 4X4, M1113

TECHNICAL MANUAL; UNIT, DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE, VOLUME 1

DECEMBER 1997

CHANGE 1

TM-9-2320-387-24-1 - Page 831 of 1205

TM 9-2320-387-24-l

1 4-64.

DIRECTIONAL

SIGNAL CONTROL CANCELLING RING REPLACEMENT

1

This task covers:

a.

Removal

b.

Installation

INITIAL SETUP:

Tools

General mechanic’s tool kit:

automotive

(Appendix B, Item 1)

Manual References

TM 9-2320-387-10

TM 9-2320-387-24P

General Safety Instructions

Failure to position cancelling pin in proper position

may cause injury to personnel or damage to

equipment.

Maintenance Level

Unit

1

a.

Removal

1

Remove three screws (5) and cancelling ring (4) from steering wheel (6).

b. Installation

WARNING

Cancelling

pin must be positioned 90” 2 5”. Ensure front wheels of

vehicle point straight ahead. Failure to position pin properly could

cause loss of steering, causing injury to personnel or damage to

equipment.

1. Install cancelling

ring (4) on steering wheel (6) with pin (2) 90’ 2 5” from directional

signal control (1).

2. Rotate steering wheel (6), ensuring pin (2) mates with directional

signal control (1) and secure

cancelling

ring

(4)

on steering wheel (6) with three screws (5).

NOTE

Gauge posts found on a new cancelling ring are there to ensure

proper installation

only. Gauge posts must be removed after

installation

of cancelling ring to permit proper operation of

directional

signal control.

3. Cut gauge posts (3) off within

l/4

in. (6 mm) of base.

FOLLOW-ON

TASK: Check directional

signal Control for proper operation (TM 9-2320-387-10).

4-105