TM-9-2320-387-24-1

TRUCK, UTILITY: S250 SHELTER CARRIER, 4X4, M1113

TECHNICAL MANUAL; UNIT, DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE, VOLUME 1

DECEMBER 1997

CHANGE 1

TM-9-2320-387-24-1 - Page 953 of 1205

TM

9-2320-387-24-l

6-l 5. REAR GEARED HUB VENT LINE REPLACEMENT

This task covers:

a.

Removal

b.

Installation

INITIAL

SETUP:

Tools

General mechanic’s tool kit:

automotive (Appendix B, Item 1)

hlanual References

TM 9-2320-387-24P

Maintenance

Level

Unit

NOTE

The

replacement procedure for each rear geared hub vent line is

basically the same. This procedure covers the right rear geared hub

vent line.

a.

Removal

1.

Disconnect vent line (4) from geared hub fitting (3).

2.

Remove capscrew (7), clamp (61, and vent line (4) from bracket (5).

3.

Remove capscrew (81, clamp (11, and vent line (4) from control arm (2).

4.

Remove capscrew (101, clamp (91, and vent line (4) from bracket (11).

5.

Remove capscrew (151, clamp (141, and vent line (4) from frame (13).

6.

Remove vent line (4) from tee fitting (12).

Lb’Installation

1.

Install vent line (4) on tee fitting (12) and geared hub fitting (3).

2.

Install vent line (4) on frame (13) with clamp (14) and capscrew (15).

3.

Install vent line (4) on bracket (11) with clamp (9) and capscrew (10).

4.

Install vent line (4) on control arm (2) with clamp (1) and capscrew (8).

NOTE

Position clamp at a 45” angle toward the wheel before securing

with capscrew.

5.

Install vent line (4) on bracket (5) with clamp (6) and capscrew (7).

6-40