TM-9-2320-387-24-1

TRUCK, UTILITY: S250 SHELTER CARRIER, 4X4, M1113

TECHNICAL MANUAL; UNIT, DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE, VOLUME 1

DECEMBER 1997

CHANGE 1

TM-9-2320-387-24-1 - Page 944 of 1205

6-11. GEARED HUB SPINDLE SEAL REPLACEMENT (Cont'd)

TM 9-2320-387-24-1

Change 1

6-31

NOTE

For new configuration, two locktabs on lockwasher must be bent

away from retaining nut for removal.

3.

Bend locktab on lockwasher (13) away from retaining nut (14).

NOTE

If four-slotted retaining nut TN-07 is present, it is recommended

to replace it with eight-slotted retaining nut 12342680.

4.

Using retaining nut wrench, remove retaining nut (14), lockwasher (13), and keyed washer (12)

from spindle (7). Discard lockwasher (13)

5.

Remove spindle (7), spacer (6), bearing (11), and spacer (10) from geared hub (1).

6.

Remove spindle seal (15) from geared hub (1). Discard spindle seal (15).

7.

Inspect spindle (7) for rough or corroded sealing surface (8). Replace geared hub (1) (para. 6-9) if

spindle (7) is damaged.

8.

Inspect bearings (9) and (11) for damage. Replace geared hub (1) (para. 6-9) if bearing (9) or (11) is

damaged.

1

6

7

9

8

10

11

12

13

14

1

15

NEW

CONFIGURATION