TM-9-2320-387-24-2

TRUCK, UTILITY: S250 SHELTER CARRIER, 4X4, M1113

TECHNICAL MANUAL; UNIT, DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE, VOLUME 2

DECEMBER 1997

CHANGE 1

TM-9-2320-387-24-2 - Page 1020 of 1555

TM 9-2320-387-24-2

1

27-3. BODY WIRING HARNESS REPLACEMENT (Co&d)

I

47.

48.

49.

50.

51.

52.

53.

54.

55.

56.

Remove two screws (231, clamps (261, and harness (27) from body (22).

Remove nut and lockwasher assembly (241, capscrew (201, clamp (211, and harness (27) from

body (22).

Discard nut and lockwasher assembly (24).

&move two screws

(14,lockwashers

(151, and shield (8) from body (22). Discard lockwashers (15).

&move

two

nut and lockwasher assemblies (181, capscrews (71, clamps (191, and harness (27) from

shield (8). Discard nut and lockwasher assemblies (18).

Disconnect harness lead 489A (13) from right rear side marker light (9).

Disconnect harness leads 21C (17), 22-461B (25), 23B (161, and 24B (6) at lefi rear composite fight (1).

&move locknut (l2), screw (lo), and harness ground lead 95C (11) from left rear side marker light (9).

Discard locknut (12).

Remove capscrew (5), lockwasher (4), and harness ground lead 95B (3) from buss bar (2). Discard

lockwasher (4).

Remove five screws (291, clamps (301, and harness (27) from body (2%

Remove four nut and lockwasher assemblies (311, capscrews (321, and trailer connector (33) from

bracket

(28).

Discard nut and lockwasher assemblies (31).

27-14