TM-9-2320-387-24-2

TRUCK, UTILITY: S250 SHELTER CARRIER, 4X4, M1113

TECHNICAL MANUAL; UNIT, DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE, VOLUME 2

DECEMBER 1997

CHANGE 1

TM-9-2320-387-24-2 - Page 1299 of 1555

33-13. RIGHT FRONT FLOOR PANEL REPAIR (Cont’d)

TM 9-2320-387-24-2

33-70

Change 1

1.

Cut metal strip (1) from sheet metal, and mark two reference lines (2), centerline (3), and

directional arrow (4). Identify metal strip (1) as A.

2.

Locate, mark, and drill twenty-four 0.187-in. (4.75-mm) diameter holes through metal strip A (1).

3.

Cut metal strip (5) from sheet metal, and mark two centerlines (6), and directional arrow (7).

Identify metal strip (5) as B.

4.

Locate, mark, and drill twenty 0.187-in. (4.75-mm) diameter holes in metal strip B (5).

5.

Cut metal strip (8) from sheet metal, and mark two centerlines (9) and directional arrow (10).

Identify metal strip (8) as C.

6.

Locate, mark, and drill eighteen 0.187-in. (4.75-mm) diameter holes through metal strip C (8).

b. Metal Strips Fabrication

METRIC CONVERSION

0.60 IN.

15.24 MM

0.75 IN.

19.05 MM

1.25 IN.

31.75 MM

1.40 IN.

35.56 MM

1.50 IN.

38.10 MM.

METRIC CONVERSION

2.00 IN.

50.80 MM

2.50 IN.

63.50 MM

3.00 IN.

76.20 MM

13.75 IN.

349.25 MM

32.50 IN.

825.50 MM

DRILL TWENTY-FOUR 0.187-IN. (4.75-MM)

DIAMETER HOLES