TM-9-2320-387-24-2
TRUCK, UTILITY: S250 SHELTER CARRIER, 4X4, M1113
TECHNICAL MANUAL; UNIT, DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE, VOLUME 2
DECEMBER 1997
CHANGE 1
TM-9-2320-387-24-2 - Page 1301 of 1555
33-13. RIGHT FRONT FLOOR PANEL REPAIR (Cont’d)
TM 9-2320-387-24-2
33-72
Change 1
1.
Using a 0.187-in. (4.75-mm) drill bit, remove twenty-eight rivets (5) from right front seat
support (3), battery tray (4), and right front floor panel (1).
2.
Using a 0.187-in. (4.75-mm) drill bit, remove fifteen rivets (5) from battery tray (4) and tunnel (2).
3.
Position insert panel (6), with arrow facing down and toward front of vehicle, to underside of right
front floor panel (1) and align to battery tray (4).
4.
Using insert panel (6) as a template, scribe an outline (8) on right front floor panel (1).
NOTE
Do not cut through front seat support when removing right front
panel section.
5.
Using scribed outline (8), cut and remove right front floor panel (1).
6.
Remove battery tray (4).
7.
Remove sharp edges and burrs on right front floor panel (1).
8.
Remove any adhesive residue and clean left front seat support (7) and tunnel (2).
9.
Position insert panel (6), with arrow facing down and toward front of vehicle, to underside of right
front floor panel (1).
10.
Obtain a minimum clearance of 0.10-in. (2.54-mm) between edges of insert panel (6) and right front
floor panel (1).
11.
Remove insert panel (6).
c. Right Front Floor Panel Removal
DRILL TWENTY-EIGHT 0.187-IN. (4.75-MM)
DIAMETER HOLES THROUGH RIVETS
DRILL FIFTEEN 0.187-IN. (4.75-MM)
DIAMETER HOLES THROUGH RIVETS
5
3
2
4
~
1
~
Back to Top
