TM-9-2320-387-24-2

TRUCK, UTILITY: S250 SHELTER CARRIER, 4X4, M1113

TECHNICAL MANUAL; UNIT, DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE, VOLUME 2

DECEMBER 1997

CHANGE 1

TM-9-2320-387-24-2 - Page 1321 of 1555

33-14. RIGHT REAR FLOOR PANEL REPAIR (Cont’d)

TM 9-2320-387-24-2

33-92

Change 1

1.

Cut two metal strips (1) from sheet metal, and mark two reference lines (2), centerline (3), and

directional arrow (4), and identify as metal strips C and D.

2.

Locate, mark, and drill twenty 0.187-in. (4.75-mm) diameter holes through metal strip C (1).

3.

Bend metal strip C (1) 1.50-in. (38.10-mm).

4.

Locate, mark, and drill twenty 0.187-in. (4.75-mm) diameter holes through metal strip D (1).

5.

Bend metal strip D (1) 1.50-in. (38.10-mm).

c. Metal Strips Fabrication

METRIC CONVERSION

2.50 IN.

63.50 MM

3.50 IN.

76.20 MM

8.50 IN.

215.90 MM

29.70 IN.

754.38 MM

METRIC CONVERSION

0.60 IN.

15.24 MM

0.75 IN.

19.05 MM

1.25 IN.

31.75 MM

1.40 IN.

35.56 MM

1.50 IN.

38.10 MM

DRILL TWENTY 0.187-IN. (4.75-MM) DIAMETER HOLES

DRILL TWENTY 0.187-IN. (4.75-MM) DIAMETER HOLES

29.70