TM-9-2320-387-24-2

TRUCK, UTILITY: S250 SHELTER CARRIER, 4X4, M1113

TECHNICAL MANUAL; UNIT, DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE, VOLUME 2

DECEMBER 1997

CHANGE 1

TM-9-2320-387-24-2 - Page 333 of 1555

TM

9-2320-387-24-2

I

1 l-62.

TURRET PINTLE MOU.NT MAINTENANCE

This task covers:

a.

Removal

b. Inspection

c.

Installation

INITIAL SETUP:

Applicable

Models

Ml114

Tools

General mechanic’s tool kit:

automotive (Appendix B, Item 1)

Maintenance and repair shop equipment:

automotive (Appendix B, Item 2)

Materials/Parts

RTV sealant (Appendix C, Item 74)

Sealing compound (Appendix C, Item 64)

Personnel

Required

One mechanic

One assistant

Manual References

TM 9-2320-387-10

TM 9-2320-387-24P

Equipment Condition

Turret hatch open (TM 9-2320-387-10X

Maintenance Level

Unit

1. Remove twelve capscrews (6) and washers (7) from turret armor (3) and turret pintle mount (1).

2. Remove capscrew (5) and washer (4) from turret armor (3) and turret pintle mount (1).

3. Remove turret pintle mount (1) from turret armor (3).

4. Remove four screws (9), pin assembly (81, and pintle brush seal (2) from turret pintle mount (1).

b. Inspection

Inspect pintle brush seal (2). Replace if damaged.

vf.Installationl

1.. Install pintle brush seal (2) and pin assembly (8) on turret pintle mount (1) with four screws (9).

Tighten screws (9) to 30 lb-in. (3 N-m).

2. Apply sealant to thirteen bosses (10) on bottom of pintle mount (1) and around holes in turret armor (3).

3. Install turret pintle mount (1) on turret armor (3) with washer (4) and capscrew (5). Do not tighten

capscrew (5).

NOTE

Apply sealing compound to capscrews prior to installation.

4. Install twelve washers (7) and capscrews (6) on turret pintle mount (1) and turret armor (3). Tighten

capscrews (6) and (5) to 37 lb-R (50 Nom).

1 l-120