TM-9-2320-387-24-2

TRUCK, UTILITY: S250 SHELTER CARRIER, 4X4, M1113

TECHNICAL MANUAL; UNIT, DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE, VOLUME 2

DECEMBER 1997

CHANGE 1

TM-9-2320-387-24-2 - Page 432 of 1555

TM 9-2320-387-24-2

12-54.6

Change 1

12-27.1. 10,500 LB HYDRAULIC WINCH AND BRACKETS REPLACEMENT (Cont'd)

NOTE

If tube assembly is installed, perform step 4.

4.

Disconnect tube assembly (16) from hydraulic hose assemblies (1) and (4).

5.

Connect hydraulic hose assembly (4) to elbow (3) on top winch inlet port on winch (15).

6.

Connect hydraulic hose assembly (1) to elbow (2) on bottom winch outlet port on winch (15).

7.

Install hydraulic hose assemblies (1) and (4) on winch and bumper assembly (15) with two clamps

(12), capscrew (11), washer (13), locknut (14).

8.

Connect controller plug lead 758B (6) to lead wire 785B (5).

9.

Connect controller plug lead 758A (8) to winch lead 758A (7).

10.

Connect controller plug lead 758C (10) to winch lead 758C (9).