TM-9-2320-387-24-2

TRUCK, UTILITY: S250 SHELTER CARRIER, 4X4, M1113

TECHNICAL MANUAL; UNIT, DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE, VOLUME 2

DECEMBER 1997

CHANGE 1

TM-9-2320-387-24-2 - Page 440 of 1555

TM 9-2320-387-24-2

12-31. FRONT WINCH CLUTCH ROD REPLACEMENT

This task covers:

a. Removal

b. Installation

INITIAL SETUP:

Applicable Models

Ml113

Tools

General

mechanic’s

tool kit:

automotive

(Appendix

B, Item 1)

MateriaWParts

Locknut (Appendix

G, Item 162)

Manual References

TM 9-2320-387-24P

Maintenance Level

unit

1

a. Removal

1

1.

Remove locknut

(91, washer

(101, rod end (121, two washers

(111, and capscrew

(13) from lever (1).

Discard locknut

(9).

2.

Remove rod end (12) from clutch rod (6).

3.

Remove clutch rod (61 through

bracket (7) and frame (2).

4.

Loosen nut (5) and remove handle (4) and nut (5) from clutch rod (6).

’

5.

Remove capscrew (3) and bracket (7) from winch (8).

b. Installation

1.

Install bracket

(7) on winch (8) with capscrew

(3).

2.

Install nut (5) and handle

(4) on clutch rod (6). Tighten

nut (5).

3.

Install clutch rod (6) through

frame (2) and bracket

(71.

4.

Install rod end (121 on clutch rod (6).

NOTE

Adjust rod end as required

to allow full clutch operation.

5.

Install capscrew

(131, two washers

(111, and rod end (121 on lever (1) with washer

(10) and

locknut (9).

12-60