TM-9-2320-387-24-2
TRUCK, UTILITY: S250 SHELTER CARRIER, 4X4, M1113
TECHNICAL MANUAL; UNIT, DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE, VOLUME 2
DECEMBER 1997
CHANGE 1
TM-9-2320-387-24-2 - Page 874 of 1555
25-12. C-PILLAR DOOR, GUIDES, TRACK, AND DOOR STOP MAINTENANCE (Cont’d)
TM 9-2320-387-24-2
25-34
Change 1
1.
Install lower track (23) on C-pillar partition (32) with seven capscrews (24) and locknuts (31).
Tighten capscrews (24) to 10 lb-ft (14 N
•
m).
2.
Install bumper (22) and nut (21) on lower track (23).
3.
Apply sealing compound to threads of seven screws (26), and install lower guide (25) on lower
track (23) with screws (26).
4.
Install door handle (19) and bracket (15) on door (14) with four capscrews (28) and two nuts (20).
Tighten nuts (20) to 10 lb-ft (14 N
•
m).
5.
Position strip (27), door (14), and strip (13) in lower guide (25).
6.
Apply sealing compound to threads of seven screws (29), and install upper guide (12) on upper
track (4) with screws (29).
7.
Install upper track (4) on C-pillar partition (32) with seven capscrews (30) and locknuts (1). Tighten
locknuts (1) to 10 lb-ft (14 N
•
m).
8.
Install left-hand evaporator bracket (5) on upper track (4) and lower track (23) with two
washers (6), capscrews (7), and locknuts (3). Tighten capscrews (7) to 10 lb-ft (14 N
•
m).
9.
Install right-hand evaporator bracket (9) and strap bracket (8) on upper track (4) and lower
track (23) with two
washers (10), capscrews (11), and locknuts (2). Tighten locknuts (2) to
10 lb-ft (14 N
•
m).
10.
Install spring (17) and thumb block (18) on bracket (15) with pin (16).
c. Installation
Back to Top
