TM-9-2320-434-10
TRUCK, LOAD HANDLING SYSTEM (LHS), 8X8, M1120
TECHNICAL MANUAL; OPERATOR'S MANUAL
JUNE 2009
TM-9-2320-434-10 - Page 843 of 1324
OPERATOR MAINTENANCE
LOAD HANDLING SYSTEM (LHS) SLAVE HYDRAULIC OPERATION
INITIAL SETUP:
Not Applicable
OPERATE LHS USING SLAVE HYDRAULIC SETUP
CAUTION
If LHS system on disabled vehicle is not in fully stowed position (transport
position), remove hydraulic tank cap from operable vehicle prior to
starting the task to allow excess hydraulic oil to drain. Failure to comply
may result in damage to hydraulic tank or hydraulic system.
NOTE
•
This procedure can only be used if there are no leaks or breaks in
the hydraulic system.
•
This procedure is used to remove the load from a vehicle with a failed
hydraulic pump or other failure which prevent operation of the
hydraulic system.
•
Each vehicle is equipped with one hydraulic slave hose. Two hoses
(one from each vehicle) are required to perform slave hydraulic
procedures. Locate and remove hoses from stowage boxes of
vehicles.
1.
Move vehicles into position so LHS control box (1) on both vehicles are side by side.
////////////////////////////////////////////////////////////////////////////////////
TM 9-2320-434-10
0118
0118-1
////////////////////////////////////////////////////////////////////////////////////
////////////////////////////////////////////////////////////////////////////////////////////////////////////////////
Back to Top
