TM-9-2320-435-10
TRUCK, COMMON BRIDGE TRANSPORT (CBT), 8X8, M1977
TECHNICAL MANUAL; OPERATOR'S MANUAL
JUNE 2009
TM-9-2320-435-10 - Page 446 of 1168
OPERATION - Continued
•
PTO ENGAGE switch must be turned off before road transport or
severe equipment damage could result.
13.
Set PTO ENGAGE switch (15) to ON position. Indicator light (16) will illuminate.
14.
Set HIGH IDLE switch (17) to ON position.
15.
Move joystick (18) to UNLOAD until bottom tip of LHS lift hook (19) is just below level
of BAP hook bar (20).
16.
Set HIGH IDLE switch (17) to OFF position.
17.
Push in PARKING BRAKE control (1) or release service brake pedal (2).
18.
Place transmission range selector (3) to R (reverse), and back up vehicle until LHS
lift hook (19) engages BAP hook bar (20).
19.
Set transmission range selector (3) to N (neutral), and pull out PARKING BRAKE
control or apply service brake pedal (2).
20.
Pull out PARKING BRAKE control (1) or apply service brake pedal (2).
CAUTION
•
Both trailer bumper points must be under vehicle bump plate and at
least one trailer bumper point must contact bump plate. Trailer
bumper point not contacting vehicle bumper stop cannot exceed 0.5
in. (12.7 mm) or the BAP will miss main rail guides and damage to
equipment may result.
•
Do not shift transmission to reverse to back up vehicle while LHS
hook arm is attached to the BAP, or damage to the LHS will occur.
21.
Ensure trailer bumper point (21) is under flange of vehicle bump plate (22).
TM 9-2320-435-10
0051
0051-10
Back to Top
