TM-9-2330-202-13-P

TRAILER, CARGO, 3/4-TON, 2-WHEEL: M101A1, M101A2 AND M101A3; TRAILER, CHASSIS, 3/4-TON, 2-WHEEL: M116A1 AND M116A2; TRAILER, CHASSIS, 1-TON, 2-WHEEL: M116A3

TECHNICAL MANUAL; OPERATOR AND FIELD MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST

DECEMBER 2011
TM-9-2330-202-13-P

  TM-9-2330-202-13-P - Page 80 of 552

OPERATION IN HIGH HUMIDITY AND SALTWATER AREAS
1.
Moist and salty areas can destroy the rust preventive qualities of oils and greases. When equipment is active,
exposed surfaces should be cleaned and lubricated daily. For proper lubrication in high humidity and saltwater
areas, refer to (WP
0077).
2.
When equipment is inactive, unpainted parts should be coated with grease. All covers and caps should be
in place.
END OF TASK
OPERATION IN MUD AND SNOW
1.
After operation in mud or snow, have Field Maintenance pack wheel bearings as required (WP
0077).
2.
For special instructions on driving hazards in snow, refer to TC 21-305-20. For better traction, reduce air
pressure to 25 psi (172 kPa).
3.
If one or more tires sink into mud or snow, it may be necessary to raise the tire and insert planking or matting
beneath it.
4.
Immediately after operation in mud and snow, thoroughly clean, inspect, and lubricate if tactical situation
permits. For proper lubrication instructions, refer to (WP
0077).
END OF TASK
OPERATION IN DUSTY OR SANDY AREAS
1.
Inspect, clean, and lubricate frequently when operating in sandy or dusty areas (WP
0077). For proper
lubrication instructions, refer to (WP
0077).
2.
Make sure no dust or sand enters exposed mechanisms or lubrication fittings during inspections and repair
operations. Cover exposed parts with tarpaulins or other suitable cover during disassembly and assembly.
3.
When beginning operation in dusty or sandy areas, remove lubricants from exposed components, such as
landing gear, if tactical situation permits. Grease and oil will cause dust and sand to accumulate and act as an
abrasive, which will cause rapid wear.
4.
Reduce tire pressure to 30 psi (207 kPa) for emergency use on beach or desert sand. Return tire pressure to
normal after emergency operation (WP
0002).
END OF TASK
OPERATION IN ROCKY TERRAIN
Use extreme caution when operating in rocky terrain. Make sure tires are fully inflated to minimize damage to tires
and tubes (WP
0002).
END OF TASK
AT HALT/PARKING
1.
For short shutdown periods, park in a sheltered spot out of the wind. For long shutdown periods, prepare a
footing of planks or brush if high, dry ground is not available.
2.
Remove all buildup of ice and snow as soon as possible after shutdown.
TM 9-2330-202-13&P
0006
0006-2


Back to Top