TM-9-2330-227-14-P
SEMITRAILER, VAN: SHOP, 6-TON, SINGLE AXLE, M146
TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)
JUNE 1985
TM-9-2330-227-14-P - Page 332 of 576
5-58
TM 9-2330-227-14&P
LANDING GEAR AND BRACKET - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
ASSEMBLY
43.
Lower leg(1 )
44.
Lower leg(1)
and nut (2)
45.
Nut (2)
46.
Screw (4 )
47.
Upper leg (6)
Slot in gib
plug (8)
Gearbox (10)
Bearing cup (
and screw (4)
Gearbox (10)
Screw (4)
11)
Nut (2)
Two pins (3)
Screw (4)
Bearing (5)
Lower leg (1)
and screw (4)
Gib (7)
Gib plug (8)
Gib spring (9)
Bearing cup (11)
Bearing cone (12)
Four bushings (13)
Key (14)
Bevel gear (15)
Nut (16)
Put in, and line up holes for pins (3).
From inside nut, push pins through
holes in nut and through wall of leg,
small diameter first.
Thread lower end of screw through nut.
Place on screw.
a. Slide into upper leg.
b. Position so groove in leg is alined
with hole for gib (7).
Put in.
a. Screw in, and tighten using 3/8-inch
flat-tip screwdriver.
b. Back off plug 1/2-turn.
Press to bottom of slot.
If removed, using 1/2-inch brass drift
and ball-peen hammer, tap in.
Slip over shaft, and seat in cup.
Using 1/2-inch brass drift and ball-peen
hammer, tap in.
Seat in keyway using ball-peen hammer.
a. Aline gear keyway with key (14).
b. Using ball-peen hammer and 1/2-inch
brass drift, tap on.
a. Jam gear (15) with wood block so it
cannot turn.
b. Screw on, and tighten using 17/16-
inch socket and handle with 3/4-inch
drive.
c. Remove block.
Back to Top
