TM-9-2330-227-14-P
SEMITRAILER, VAN: SHOP, 6-TON, SINGLE AXLE, M146
TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)
JUNE 1985
TM-9-2330-227-14-P - Page 338 of 576
TM 9-2330-227-14&P
U-BOLTS, RADIUS ROD AND BRACKET, AND SPRING - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
REMOVAL
1.
Screw (1)
2.
Radius rod (4)
and bracket (5)
3.
Radius rod
bracket (5)
4.
Sleeve
bushing (7)
5.
Radius rod (4)
and bracket (5)
6.
Two nuts (9)
7.
Two screws (11)
8.
Spring brackets (12)
9.
Two U-bolts (13)
10.
Axle (16) and
radius rod
bracket (5)
11.
Spring (17)
12.
Radius rod
bracket (5)
13.
5-64
Retaining nut (2)
and nut (3)
Screw (1)
Two retainers (6)
Setscrew (8)
Sleeve bushing (7)
Two cotter pins (10)
Two nuts (9)
Two screws (11)
Four nuts (14)
and washers (15)
Two U-bolts (13)
Radius rod
bracket (5)
Two washers (18)
Two rubber
bushings (19)
Using 15/16-inch socket, ratchet handle
with 1/2-inch drive, and 15/16-inch open-
end wrench, unscrew and take off.
Using 1/2-inch driftpin and ball-peen
hammer, tap out.
Using 3/16-inch fiat-tip screwdriver,
take off.
Using 5/8-inch socket, 4-inch extension,
and ratchet handle with 1/2-inch drive,
unscrew and take out.
a. Using 1-inch drive-pin punch and
ball-peen hammer, drive out.
b. Repeat steps 1 thru 5 for other end.
c. Take radius rod (4) off.
Using straight-nose slip-joint pliers,
straighten and take out.
Using 15/16-inch socket, ratchet handle
with 1/2-inch drive, and 15/16-inch open-.
end wrench, unscrew and take off.
Take out.
Using 1 7/16-inch socket, 6-inch
extension, and ratchet handle with 3/4-
inch drive, unscrew and take out.
Using ball-peen hammer and 1/2-inch
driftpin, tap out.
Lift off.
Take out.
Using 1 3/4-inch drive-pin punch and
ball-peen hammer, tap out.
Back to Top
