TM-9-2330-238-14
CHASSIS, SEMITRAILER: 6-TON, 4-WHEEL M295A1; SEMITRAILER, VAN: EXPANSIBLE, 6-TON, 4-WHEEL M313; SEMITRAILER, VAN: SHOP, FOLDING SIDES, 6-TON, 4-WHEEL M447 AND M447C; SEMITRAILER, VAN: REPAIR PARTS, SHOP EQUIPMENT, 6-TON, 4-WHEEL M749; SEMITRAILER, VAN: REPAIR PARTS STORAGE, 6-TON, 4-WHEEL M750
TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL
JULY 1992
TM-9-2330-238-14 - Page 361 of 462
TM
9-2330-238-14
5-19.
RIGHT
REAR DOOR AND SIDE DOOR LOCKS REPLACEMENT
(M313,
LATE MODEL)
(Con’t).
WARNING
Dry cleaning
solvent,
P-D-680,
is toxic and flammable.
Always wear protective
goggles
and gloves,
and use only in a well-ventilated
area.
Avoid contact
with skin, eyes,
and
clothes,
and DO NOT breathe
vapors.
DO NOT use near open frame or excessive
heat.
The
solvent’s
flash
point
is 100°F-138°F
(38°C-59°C).
If you
become
dizzy
while
using cleaning
solvent,
immediately
get fresh air and medical
help. If solvent
contacts
eyes,
immediately
wash your eyes and get medical
aid.
1.
Clean
all parts with dry cleaning
solvent
and dry thoroughly.
2.
Inspect
latch and door
bolts
for ease of operation.
3.
Inspect
connecting
links for cracks,
bends,
or breaks.
Straighten
any minor
bends.
4.
Replace
any defective
parts.
1.
From outside
of door
screws
(9).
(10), position new gasket
(7) and outer door handle
(8) in place
on door and install three
2.
From inside
of door
(10), position
latch (6) and connecting
links (5 and 12) in place
and install four screws
(3).
3.
Position
exit bolt
(11) and flush
bolt
(4) in place
on door
(10) and install
eight
screws
(3).
4.
Install connecting
links (5 and 12) in place on exit bolt (11)
and flush bolt (4) and secure with two capscrews (14)
and new Iockwashers
(13).
5.
Position
door
handle
(1) in place
on shaft with holes alined
and install
grooved
headless
pin (2).
6.
Lubricate
latch
(6) and bolts
(4 and 11) in accordance
with Lubrication
Instructions
(Chapter
3, Section
I).
5-59
Back to Top
