TM-9-2330-324-14-P

TRAILER, CARGO: 1-1/2-TON, 2-WHEEL, M105A3

TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

JULY 2002

TM-9-2330-324-14-P - Page 183 of 350

TM 9-2330-324-14&P

0038 00-5/(6 blank)

BLEEDING BRAKE SYSTEM—Continued

0038 00

PRESSURE BLEEDING—Continued

16.

Master cylinder (8) should be approximately 3/4 full. Add brake fluid as necessary.

17.

Remove two cotter pins (16) and master pins (17). Discard cotter pins.

18.

Move inner casing (15) slowly back and forth while watching inside of master cylinder (8) being

careful not to pull inner casing out of actuator. Continue movement back and forth several times until

no air bubbles are visible in master cylinder.

19.

Install two master pins (17) and new cotter pins (16).

CAUTION

Do not use any tool to tighten

filler cap (7)—finger-tighten

only.

Failure to follow this caution could result in damage to equipment.

20.

Install filler cap (7) on master cylinder (8).

21.

Install cover (5) and two screws (6).

6

17

8

5

7

15

16

END OF TASK