TM-9-2330-324-14-P

TRAILER, CARGO: 1-1/2-TON, 2-WHEEL, M105A3

TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

JULY 2002

TM-9-2330-324-14-P - Page 232 of 350

TM 9-2330-324-14&P

0052 00-4

AXLE REPLACEMENT—Continued

0052 00

INSPECTION AND REPAIR

1.

Check threads of axle spindle for wear, crossed threads, or other damage.

2.

Using fine file, remove burrs, or hand chase threads if necessary.

3.

Check axle spindle for bend. Indications of a bent axle spindle are binding bearings, which cannot

be adjusted properly, and extremely uneven wear of brake linings. Replace axle if spindle is

defective.

4.

Check for damaged paint and repaint where necessary.

INSTALLATION

WARNING

Axle (2) is heavy and awkward to handle. Use caution, provide adequate

support, and use assistance during installation. Failure to follow this

warning may result in serious injury.

1.

Position axle (2) on dolly.

2.

Place support under axle (2).

3.

Carefully raise and position axle (2) on springs (21). Support axle at both ends.

4.

Install four U-bolts (22), two plates (19), and eight new locknuts (20) on axle (2) and springs (21).

5.

Tighten nuts (20) to a torque of 223 lb-ft (302 N•m).

21

20

19

2

22