TM-9-2330-326-14-P
SEMITRAILER, TACTICAL, DROP DECK BREAKBULK/CONTAINER TRANSPORTER, 22-1/2 TON, M871A3
TECHNICAL MANUAL; OPERATOR’S, UNIT, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)
FEBRUARY 2006
TM-9-2330-326-14-P - Page 71 of 540
TM 9-2330-326-14&P
4-11
Table 4-1. Unit PMCS (Cont.)
ITEM
NO.
INTERVAL
M
S
A
T
MI
ITEM TO
CHECK/
SERVICE
PROCEDURE
EQUIPMENT NOT
READY/
AVAILABLE IF:
16
M
S
A
T
MI
Every
?
12,000
Wood Decking
Corrosion
Apply a coat of UV wood or linseed oil
protector to upper and lower deck
surfaces.
Board(s) are
broken or
missing.
17
M
S
A
T
MI
Every
?
36,000
Wheel
Bearings
WARNING
•
Do not use air pressure or a steel
bristle brush to clean cones and
rollers. Use kerosene or diesel fuel
to
clean
bearings.
Do not
use
gasoline. Do not rotate bearings
using compressed air, as this will
damage
the
polished
surfaces.
Bearing failure can cause injury.
•
At triennial brake inspection/service
all brake wheel end components
must be cleaned and inspected for
wear/damage. Inspect all linings,
springs, pins, rollers, clips and
bushings on each axle end. Make
sure seals show no signs of leakage
on axle, spider or wheels. Use all
components of replacement kits and
balance repairs on both axle ends.
Failure to comply can cause injury
to personnel and damage to the
equipment.
Clean, inspect, and repack inner and outer
cones and rollers. Replace if damaged or
worn.
Worn or
damaged.
18
M
S
A
T
MI
Every
? 36,000
Seals
Check condition of seals for indicators of
problems. When seal is removed, it should
be replaced. Use correct seal installation
tool to drive/seat seal and never re-use a
seal.
Seal is damaged,
worn, or leaking.
19
M
S
A
T
MI
Every
? 36,000
Spindle
Check spindle for damaged threads and
surface area for rust/pitting. Notify Direct
Support maintenance.
Spindle is
damaged.
Back to Top
