TM-9-2330-328-14-P
CHASSIS, CONTAINERIZED KITCHEN TRAILER: 7 1/2-TON, 4-WHEEL XCK2000 AND XCK2000E1
TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)
DECEMBER 2001
TM-9-2330-328-14-P - Page 108 of 254
TM9-2330-328-14&P
MAINTENANCE OF ELECTRICAL SYSTEMS- Continued
0015 00
WIRING HARNESS
Materials/Tools
General mechanics tool kit
Electrical tool kit
Soldering iron
Wiping rag (WP 0026 00)
NOTE
Remove complete harness only if required to effect repair or replacement.
a. Removal.
(1) Remove electrical connection cover plate at front of trailer.
(2) Tag and disconnect harness connectors
(1 and 2)
at all lights.
(3) Remove tie wraps
around harness
(3)
at composite light mounting bracket.
(4) Remove two lock nuts and cap screws to free ground lead
(4)
from frame.
NOTE
To make installation easier, tape connector bundles to main harness if desired.
(5) Feed wire harness
(3)
through clamps
(5)
and along frame while pulling
harness from the frame.
b. Cleaning and Inspection.
(1) Clean wiring harness with a clean rag.
(2) Inspect wiring for cuts, breaks and loose connections, and connectors and cover for
damage.
c. Repair.
(1) If any connector terminal
(1)
is damaged, replace it. Push back shell
(2)
on wire to
expose terminal
(1)
, remove defective terminal, and crimp a new terminal on end of wire.
Pull shell over terminal.
0015 00-4
Back to Top
