TM-9-2330-331-14-P
SEMITRAILER, FLATBED: BREAKBULK/CONTAINER TRANSPORTER, 34 TON, M872A4
TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL WITH REPAIR PARTS AND SPECIAL TOOLS LISTS
DECEMBER 2005
TM-9-2330-331-14-P - Page 99 of 472
TM 9-2330-331-14&P
0015 00
Table 3.
Operator/Crew PMCS - Continued
ITEM
MAN-
ITEM TO BE
EQUIPMENT
NO.
INTERVAL HOUR
CHECKED OR
SERVICED
PROCEDURE
NOT READY/
AVAILABLE IF:
5
Before
.25
Lights
a. Connect 12-volt intervehicular cable
from tractor to semitrailer.
Check lights
for damage, proper operation, and
missing hardware.
Lights are
damaged, do not
operate, or missing
hardware.
NOTE
Remove 12-volt cable before
beginning step b.
b. Connect 24-volt intervehicular cable
from tractor to semitrailer.
Check lights
for damage, proper operation, and
missing hardware.
Lights are
damaged, do not
operate, or missing
hardware.
6
Before
.10
Reflectors
Look for damage and missing hardware.
NOTE
Reflectors are
missing and
required for
mission.
•
Tractor must be coupled
before checking ABS warning
light.
•
ABS warning light should
not stay on when semitrailer
is moving above 4 mph
(6.4 km/h).
•
If mission requirements do
not allow for troubleshooting of
ABS system, continue on
with mission until system can
be properly diagnosed by
Organizational Maintenance.
Only modulation will be
affected, not stopping
capacity of brake system.
7
Before
.10
ABS
Visually check that the ABS warning light
does not stay on.
ABS light does not
come on or stays
on.
0015 00-3
Back to Top
