TM-9-2330-334-13-P
FAMILY OF MEDIUM TACTICAL VEHICLES (FMTV) LOAD HANDLING SYSTEM TRAILER (LHST) M1147A1
TECHNICAL MANUAL; OPERATOR AND FIELD LEVEL MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST (RPSTL)
DECEMBER 2013
CHANGE 1
TM-9-2330-334-13-P - Page 313 of 1184
TM 9-2330-334-13&P
PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS)
INCLUDING LUBRICATION INSTRUCTIONS - Continued
0052 00
0052 00-5
Change 1
LUBRICATION SERVICE INTERVALS - NORMAL CONDITIONS - Continued
WARNING
•
Solvent, Cleaning Compound (MIL-PRF-680) is TOXIC and flammable.
Wear
protective goggles and gloves; use only in well-ventilated area; avoid contact
with skin, eyes, and clothes, and do not breath vapors.
Keep away from heat or
flame.
Never smoke when using Cleaning Solvent; the flashpoint for Type I
Cleaning Solvent is 100°F (38°C) and for Type II is 138°F (50°C). When not
using MIL-PRF-680 solvents, ensure MIL-PRF-680 solvent container is sealed.
Store, handle, and dispose of unused and spent solvents in accordance with
local procedures and plans.
Failure to comply may result in serious injury or
death to personnel.
•
If personnel become dizzy while using Dry Cleaning Solvent, immediately get
fresh air and medical help.
If Dry Cleaning Solvent contacts skin or clothes,
flush with cold water.
If Dry Cleaning Solvent contacts eyes, immediately flush
eyes with water and get medical attention.
Failure to comply may result in
serious injury or death to personnel.
Cleaning Fittings Before Lubrication.
Clean parts with Dry Cleaning Solvent (SD II, MIL-PRF-680) or
equivalent. Dry before lubricating. Dashed arrows indicate lubrication on both sides of equipment.
Lubrication After Fording.
If a fording operation occurs, lubricate all fittings below fording depth and
check submerged gear boxes for presence of water.
Lubrication After High Pressure Washing.
After a thorough washing, lubricate all grease fittings and oil
can points outside and underneath trailer.
Lubrication Local Views.
A reference to the appropriate localized view is given after most lubrication
entries.
Corrosion Control
Refer to WP 0001 00, Corrosion Prevention and Control (CPC), for appropriate corrosion control procedures.
Hard Time Lubrication Intervals
For equipment under manufacturer’s warranty, hard time lubrication intervals shall be followed. Intervals
shall be shortened if lubricants are known to be contaminated or if operation is under adverse conditions
(e.g. longer than usual operating hours, extended idling periods, extreme dust).
Back to Top
