TM-9-2330-335-14-P

SEMITRAILER, TACTICAL, BREAKBULK/CONTAINER TRANSPORTER, 22-1/2 TON, RESET M871R, M871A1R AND M871A2R

TECHNICAL MANUAL; FIELD AND SUSTAINMENT MAINTENANCE MANUAL (INCLUDES REPAIR PARTS AND SPECIAL TOOLS LIST)

SEPTEMBER 2008

TM-9-2330-335-14-P - Page 614 of 640

TM 9-2330-335-14&P

0110-2

0110

INSTALLATION - CONTINUED

6.

Install the slack adjuster onto the camshaft with the adjusting hex pointing away from the brake chamber.

7.

Secure the slack adjuster on the camshaft. Use at least one inner washer and enough outer washers to allow no more than

.060 in. movement of adjuster on camshaft.

NOTE

DO NOT pull push rod out to meet the brake adjuster.

8.

Rotate the 7/16 in. adjusting hex nut clockwise until the clevis hole lines up with the brake adjuster arm hole.

Figure 2.

Installation.

0110

9.

Apply antiseize to clevis pin, install, and secure with cotter pin.

10. The S-ABA control arm can be placed anywhere within the range of the bracket slot for automatic adjustment to take

place. Haldex recommends, however, rotating all control arms towards the axle until they come to a complete stop and

securing in that position. This will create a “common” position for all wheels.

11. Tighten all anchor bracket fasteners.

Figure 3.

Installation.

0110

END OF TASK

447-0166

447-0167