TM-9-2330-335-14-P

SEMITRAILER, TACTICAL, BREAKBULK/CONTAINER TRANSPORTER, 22-1/2 TON, RESET M871R, M871A1R AND M871A2R

TECHNICAL MANUAL; FIELD AND SUSTAINMENT MAINTENANCE MANUAL (INCLUDES REPAIR PARTS AND SPECIAL TOOLS LIST)

SEPTEMBER 2008

  TM-9-2330-335-14-P - Page 611 of 640

0109-1
TM 9-2330-335-14&P
0109
FIELD AND SUSTAINMENT MAINTENANCE
-
HUBODOMETER®
Installation Instructions, General Information, Care of HUBODOMETER®
INSTALLATION INSTRUCTIONS
000109
1.
Mount HUBODOMETER® to face of hubcap or bracket.
2.
Use washer under locknut.
3.
Use 15 lb-ft (20.3 Nm) of torque to tighten locknut. DO NOT USE AIR IMPACT WRENCH. DO NOT EXCEED
15 lb-ft (20.3 Nm) OF TORQUE.
4.
If necessary, use strap wrench to hold HUBODOMETER® while tightening.
5.
DO NOT USE PAINTS, SOLVENTS, OR THINNERS ON THE HUBODOMETER® FACE, GRILAMID HUBCAP,
OR HUBODOMETER® HUBCAP WINDOW.
6.
The recommended torque for the 3/8 in. pipe plug for aluminum hubcaps is 9 lb-ft (12.2 Nm). A suitable sealant may be
used on the pipe plug threads if desired. On Grilamid hubcaps with plastic fill plug and O-ring, tighten to a torque not to
exceed 10 lb-ft (13.6 Nm).
7.
The proper oil level for the STEMCO HUBODOMETER® window is indicated by the inside protruding ledge of the
window (Figure 1).
Figure 1.
HUBODOMETER®.
0109
END OF TASK
GENERAL INFORMATION
000109
HUBODOMETER®
000109
1.
Basically a driveless, mechanical-meter, hub-mounted odometer. The name HUBODOMETER® is actually a
registered trademark name for a specific STEMCO product.
2.
The accuracy of the HUBODOMETER® is plus or minus 2 percent.
3.
It is specifically calibrated to a tire size, make and model, and to the mid-life of the tire tread, not the depth of new tire
treads.
447-0260
2


Back to Top