TM 9-2330-335-14&P
0108-4
0108
INSTALLATION - CONTINUED
8.
Inspect the installation to make sure that the keeper outer tab and the keeper arms are fully seated into the undercut groove
in the nut. Use the small bladed screwdriver to gently flex the keeper arms to ensure they fully engage the groove in the
nut. Visually inspect the seating and that the teeth are fully engaged in the nut teeth.
9.
Inspect the square keeper tang to make sure it does not contact the bottom of the square groove on the axle spindle.
10. Check the bearing setting by using a dial indicator to verify the bearing end play. The nut will produce a consistent setting
of 0.001 to 0.003 in. (0.025 to 0.076 mm) end play.
END OF TASK
END OF WORK PACKAGE