TM 9-2330-335-14&P
0005-14
0005
AFTER USE
0005
1.
Lowering Landing Gear.
WARNING
•
Ensure landing leg scissor assemblies retaining (hitch) pins are installed extending inward. If
installed extending outward, they will be a contact hazard and may result in injury to personnel.
•
Watch hands and fingers when removing/installing ground boards. Fingers/hands could be pinched
or cut if not careful when removing/installing ground boards.
NOTE
Park semitrailer with bulkhead end slightly elevated to allow any water to run off.
a.
If ground is soft, position ground boards (Figure 13, Item 4) under sand shoes of legs (Figure 13, Item 3).
b.
Lift crank (Figure 13, Item 1) from crank hanger (Figure 13, Item 2).
c.
Raise crank (Figure 13, Item 1) to operating position. Push crank in for low speed operation.
d.
Turn crank (Figure 13, Item 1) clockwise until legs (Figure 13, Item 3) are extended.
e.
Lower crank (Figure 13, Item 1) and secure in crank hanger (Figure 13, Item 2).
Figure 13.
Landing Legs.
05
447-0021