TM-9-2330-342-10

PALLETIZED LOAD SYSTEM TRAILER (PLST) M1076 A1

TECHNICAL MANUAL; OPERATOR'S MANUAL

SEPTEMBER 2012

TM-9-2330-342-10 - Page 447 of 500

REMOVAL - Continued

WARNING

If tire has been run flat, or is over or under inflated when tire is measured

and operating terrain is compared to Unsafe Tire Inflation Pressures, or

if wheel/tire assembly has obvious or suspected damage, it is not safe to

adjust tire pressure. Completely deflate tire (WP

0054), and remove tire

from axle. Failure to follow these procedures may result in injury or death

to personnel.

NOTE

•

Air wrench from PLS vehicle may be used in place of sliding

handle and extension wrench.

•

Trajectory area as shown applies to all wheel/tire assemblies.

Table

1.

Unsafe Inflation Pressures.

Spare Tire Is:

Spare Tire Is:

Overinflated. Tire pressure

measured is 25% or more

above standard

pressure.Do not adjust

pressure if above pressure

shown above.

Underinflated. Tire pressure

measured is 80% or less

than the standard tire

pressure.Do not adjust

pressure if below pressure

shown below.

Spare Tire Pressure

109 psi (752 kPa)

70 psi (483 kPa)

1.

Take tire pressure reading on spare tire and compare reading to Table 1. If tire is

overinflated or underinflated or there is obvious or suspected damage to tire or wheel

components, completely deflate tire (WP

0054) and stand out of trajectory range

before lowering tire from trailer.

2.

Remove slide handle, extension wrench, and socket from stowage box (Figure 1, Item

1).

TM 9-2330-342-10

0055

0055-3