TM-9-2350-238-10

RECOVERY VEHICLE, FULL-TRACKED: LIGHT, ARMORED, M578

OPERATOR’S MANUAL

APRIL 1990

  TM-9-2350-238-10 - Page 170 of 291

TM 9-2350-238-10
Table 3-1. TROUBLESHOOTING–CONTINUED
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
TRACKS AND SUSPENSION–CONTINUED
Step 2. Check for suspension lockout cylinder that did not release.
Place lockout control handle in UNLOCK position. Drive vehicle so
high side track wheels roll over a 4 x 4 or other obstacle. If any
wheel does not lift up, notify unit maintenance personnel.
NOTE
Vehicles have eight lockout cylinders.
Lockout cylinders are not mounted on
third from front road wheels.
CAB, BOOM, AND WINCHES
30. CAB, BOOM, AND WINCHES DO NOT RESPOND TO CONTROLS.
Step 1.
Check to see if engine is operating at idle speed.
Activate hydraulic system. Refer to page 2-67,
Step 2. Check hydraulic reservoir gauge for low or no hydraulic oil in reservoir.
Fill hydraulic reservoir to proper level (appx G).
Activate hydraulic system. Refer to page 2-67.
If trouble continues, notify unit maintenance personnel.
Change 3
3-23


Back to Top