TM-9-2350-238-20-1

HULL AND RELATED COMPONENTS RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL

MAY 1994

TM-9-2350-238-20-1 - Page 1100 of 1364

TM 9-2350-238-20-1

2-189. MAINTENANCE OF DRIVER’S WINDSHIELD ENCLOSURE KIT—DRIVER’S

BASE ASSEMBLY AND RELATED PARTS AND ENCLOSURE (CONT).

REMOVAL

1

2

3

4

5

Failure to remove or disconnect

batteries before removing or installing

any electrical wiring harness or lead

may result in injury or damaged

equipment.

Tag and disconnect all electrical leads.

Refer to page 2-371.

Remove wiper blade clip (1) and wind-

shield wiper arm (2) from windshield wiper

motor assembly (3). Remove windshield

wiper blade (4) from windshield wiper arm.

NOTE

Nut lockwasher, cup washer, and

rubber washer are supplied with

windshield wiper motor assembly.

Use care not to lose or damage these

components.

Remove nut (5), lockwasher (6), cup

washer (7), and rubber washer (8) from

windshield wiper motor assembly (3).

NOTE

The cover on the windshield wiper

motor assembly must be removed to

gain access to some of the wind-

shield wiper motor assembly attach-

ing hardware.

Remove six machine screws (9), six

lockwashers (10), and cover (11) from

windshield wiper motor assembly (3).

Remove machine screw (12), flat washer

(13), windshield wiper motor assembly (3),

and three flat washers (14).

2-1074