TM-9-2350-238-20-1
HULL AND RELATED COMPONENTS RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578
TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL
MAY 1994
TM-9-2350-238-20-1 - Page 35 of 1364
TM 9-2350-238-20-1
Table 2-1. SERVICE UPON RECEIPT-M578 RECOVERY VEHICLE
LOCATION
ITEM ACTION
d.
e.
f.
g.
h.
i.
j.
k.
l.
Remove securing fastenings from:
impact wrench access door, engine air
cleaner access doors, rigger's door,
stowage compartment access door, tool
locker door, crane operator's door, tow
winch access door, crane operator’s
cupola cover, and rigger/gunner cupola
cover.
Remove securing straps from: portable
fire extinguishers, outside and inside of
cab; snatch block on left front of cab;
tow winch snatch block in tray or bottom
of boom; level wind; two tow-cables,
one each side of boom; tow bar on right
fender; track shoes on right deck;
acetylene and oxygen cylinders on right
front of cab; and all chains in exterior
cab stowage compartment.
Remove tape and barrier material from
machine gun pintle support.
Remove machine gun mount from cab.
Remove tape and barrier material and
install mount on pintle support.
Remove Ml 7 periscopes from inside
cab stowage compartment. Remove
tape, paper, and cushioning material.
Install periscopes in driver’s, crane
operator's, and rigger/gunner cupolas.
Remove tape and protective cover from
headlamps, taillights, flasher, and
floodlights.
Remove tape and protective cover from
all seats, backrests, and crash pads.
Remove screen from turret hull cleanout
cover opening. Remove wire securing
cover and close cover.
Remove screens from transmission and
radiator access cover openings.
(CONT)
REMARKS
2-9
Back to Top
