TM-9-2350-238-20-1

HULL AND RELATED COMPONENTS RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL

MAY 1994

TM-9-2350-238-20-1 - Page 431 of 1364

TM 9-2350-238-20-1

11

Slide final drive coupling nut (21) onto

transmission shaft (19). Tighten coupling

nut, using drift and hammer or spanner

wrench.

12

Punch a dent in edge of final drive

coupling nut (21) about 1/32 in. (0.8 mm)

into two of four notches (22), using small

punch. Replace final drive coupling nut if

dents cannot be punched in undented sur-

face.

13

Install new seal (23) in groove in right

output drive cap (24). Trim seal (23) to

stick out 0.09 in. (2.30 mm) past mating

surface of right output drive cap (24).

2-405