TM-9-2350-238-20-2

CRANE (CAB) COMPONENTS RECOVERY VEHICLE, FULL TRACKED: LIGHT,ARMORED, M578

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL

MAY 1993
CHANGE 1

  TM-9-2350-238-20-2 - Page 129 of 495

WARNING
TM 9-2350-238-20- 2
DISASSEMBLY
1
2
3
4
Remove capscrew (1), Iockwasher (2), fla t
washer (3), and door lock-release lever (4)
from access door (5) .
Remove three capscrews (6), three lock -
washers (7), and stowage door handle (8 )
from access door (5) .
If damaged, remove two nonmetallic seal s
(9) from top and bottom of access door
opening (10) .
If damaged, remove nonmetallic seals (11 )
from both sides of access door openin g
(10) .
INSPECTION/REPAI R
1
Check for broken, damaged, or missin g
parts .
2
Repair is by replacement of authorize d
parts (TM 9-2350-238-24P-2) .
REASSEMBL Y
Dry cleaning solvent is toxic an d
flammable. Wear protective goggle s
and gloves and use only in well-
ventilated areas .
1
Remove residual adhesive from rear of ac -
cess door opening (1) using dry cleanin g
solvent (item 10, appx C) and wire brush .
2
Apply epoxy resin adhesive (item 2, app x
C) to two new nonmetallic seals (2), tw o
new nonmetallic seals (3), and mountin g
area on rear of access door opening (1) .
Install new nonmetallic seals (2) and (3)
on access door opening (1) .
3
Install stowage door handle (4) on access door (5) and secure with three new Iockwasher s
(6) and three capscrews (7) .
4
Install door lock-release lever (8), flat washer (9), new Iockwasher (10), and capscrew (11 )
on access door (5) .
2-8 9


Back to Top