TM-9-2350-238-20-2

CRANE (CAB) COMPONENTS RECOVERY VEHICLE, FULL TRACKED: LIGHT,ARMORED, M578

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL

MAY 1993

CHANGE 1

TM-9-2350-238-20-2 - Page 121 of 495

TM 9-2350-238-20- 2

NOT E

Steps 1 thru 3 are written for

removal of left side cab swingin g

metal door, but also apply to re-

moval of left rear cab swingin g

metal door, right rear vehicle ca b

hatch door, and right side cab vehi-

cle hatch door .

1

Remove cotter pin (1) and slotted nu t

(2) .

2

Open left side cab swinging meta l

(3), lift off hinges (4), and remov e

cab (5) .

doo r

fro m

3

Remove two sleeve bearings (6) fro m

hinges (4) .

4

If damaged, remove nonmetallic seal (7 )

from left side cab swinging metal doo r

opening (8) .

5

If damaged, remove nonmetallic seal (9 )

from right side cab vehicle hatch door

opening (10) .

6

If damaged, remove two nonmetallic sea l

tabs (11) from left rear cab swingin g

metal door (12) .

7

If damaged, remove nonmetallic seal (13 )

from left rear cab swinging metal doo r

(12) .

8

If damaged, remove nonmetallic gaske t

(14) from rear door opening (15) of ca b

(5) .

9

Remove two cotter pins (16); lif t

hydraulic reservoir filter access door (17)

to upright position and remove .

10

Remove self-locking nut (18), flat washer (19), capscrew (20), and flat washer (21) .

11

Remove helical spring (22) and crane operator’s hatch thumb latch (23) .

12

Remove four capscrews (24), four Iockwashers (25), and right and left cab door catc h

springs (26) .

13

Remove four hexagon plain nuts (27), four Iockwashers (28), four capscrew s

receptacle hole slave access cover (30) .

14

Remove pipe plug (31) from floor inside rear cab stowage compartment (32) .

(29), an d

2-8 1